Drag Link Insert for High Angle Drag Link

SKU: R1589 Drag Link Insert for High Angle Drag Link

Click image to zoom

Description
Reviews

Drag Link Insert for High Angle Drag Link

Just what you need to get that High Angle Drag Link in your pitman arm on our Y-Link kit using the GM 1 ton high angle rod end (about 0.77" on the large end of the taper). Hole must be drilled out to 1". You may need to grind the end with no shoulder down a little bit in order to get a snug fit. These are designed to be welded, preferably in the TIG process due to the small overall size, however MIG welding them is acceptable as well.

Write Review

★★★★★ ★★★★★

5/5 Stars out of 6 Reviews

1 ★

2 ★

3 ★

4 ★

5 ★

Pages 1 2

Verified Buyer

Great Insert, Lot if Work

★ ★ ★ ★ ★ 5

Connor Koons (Detroit) | November 4th, 2020

Insert is very nice and exactly what I wanted, be prepared to spend a lot of time drilling out the pitman arm to fit this however, invest in a quality drill bit or reamer

Verified Buyer

Timely

★ ★ ★ ★ ★ 5

Shirley (PHOENIX, AZ, US) | November 10th, 2019

The product I received was exactly what I ordered, and was sent in a timely fashion. I will shop RS again

Verified Buyer

Great Item

★ ★ ★ ★ ★ 5

Bob Bohannon (Gravette, AR, US) | September 3rd, 2018

Used it in a toyota IFS pitman arm to allow the use of the GM 1 ton draglink. It works great and easy to install. I can see many other uses for this item. Shipping was fast and courteous as always.

Verified Buyer

Missing link of steering

★ ★ ★ ★ ★ 5

Garrett Hingst (Allen, NE, US) | August 19th, 2016

Great upgrade to high angle steer knuckles and quick shipment

Verified Buyer

Top Notch as always

★ ★ ★ ★ ★ 5

Scott Bowers (altoona, PA, US) | June 4th, 2015

Never a doubt when ordering from ruff stuff. Fast shipping! Great product, no issues, and does what it's supposed to.

WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.