For Class V hitch receivers.
NO NEED TO SLEEVE Class V hitch receivers to weaker Class III and Class IV.
Finally a hitch receiver shackle mount designed for Class V receivers. Only available in Military Specification Anodizing (Mil-A-8625 F Type III) hard anodized gray finish.
The HitchLink 2.5 will accept both � and 7/8 shackles. It can be oriented inside the hitch receiver allowing the shackle tab to be parallel to the bumper or vertical depending on its desired need. It also eliminates the need to use a receiver sleeve to downsize your receiver to a 2" adapter. Rated at 18,000 lbs. Ultimate Failure at 69,000 lbs.
MADE IN THE USA
Use your receiver as a recovery tow point.
- Lightweight precision CNC machined 6000 series aluminum
- Weighs only 3.6 lbs pounds
- Rated at 18000 pounds
- Ultimate failure at 69,000 pounds
- Fits standard Class V 2.5 inch receivers
- Fits common �" (7/8" pin) and 7/8" (1" pin) screw pin shackles/D-rings
- Available in the Military Specification Anodizing (Mil-A-8625 F Type III) Gray
- Cross drilled hitch pin attachment (vertical or horizontal shackle pin axis)
WARNING:
- Never exceed factory receiver hitch pull rating
- Always use a quality steel alloy 5/8" hitch pin
- Always pull in line with the hitch, do not bind or side load the shackle
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
