Dana 70 Disc Brake Bracket Pair (Chevy Dually axle using single rear wheel)
This is for converting to standard single steel wheel minimum 15" with a maximum 4" back spacing. Will not work with dually wheels
This is the bracket for your Chevy Dana 70 C and C axle. I developed these after the success of our 14 Bolt brackets and seeing what was available on the market and the problems associated with the others. The Dana 70 was used by all of the Big 3 automakers and they all had different uses and designs specifically for them. These are for a Chevy Dana 70 Dually only. These are for Dual Rear Wheel (DRW) axles not Single Rear Wheel (SRW) axles. Both the Dodge and Ford have different flanges and tube diameters. We have actually identified 4 different flanges in use and 3 tube diameters. How can 1 size fit all? So Please, don't buy the 1 size fits all available out there, you may get lucky and have it work but the odds are against you.....These also use the 73-87 Chevy 3/4 Ton Front Rotors and Calipers. They will need the rotor throat opened ~3/16" to fit on the back side of the hub.
*NOTE* Double check stud diameter, studs should drop freely into the rotor. DO NOT press studs into the rotor. If your hub has too large of studs you will need to drill the rotors to accept them. Be sure to have minimum 5/8" lug nut thread engagement once the wheel is installed
Use these brackets with our calipers found here GM Dual Bleeder Loaded Brake Caliper (ruffstuffspecialties.com)
NAPA Part numbers for '73-'87 3/4 Ton Front, 4x4, Chevy Calipers and Rotors:
Caliper ONLY: LH - N4674, RH - N4673 - Both of these are LATER year part numbers
OR
LH - N4597, RH - N4596 - Both of these are EARLIER year part numbers
Rotor Only - 4885677 - all years
Brake line - H86572
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
