Ford 9" Weld On Disc Brake Brackets, 3.5" Tubes

SKU: R1261 Ford 9" Weld On Disc Brake Bracket Pair 3.25"-3.5" Axle

Click image to zoom

Description
Reviews

Ford 9" Weld On Disc Brake Bracket Pair 3.25"-3.5" Axle

These can be used on 3.25"- 3.5" diameter axle tubes and are made for the 11.75" diameter Bronco 5 on 5.5" rotors and the inexpensive '73-87 Chevy 3/4 ton 4x4 front caliper. You can use any of the 20 or so high performance calipers that share the 7.05" caliper pin spacing also but the Chevy seems more than good enough for nearly everyone.

These are 3/8" thick

Sold in pairs

Use these brackets with our calipers found here GM Dual Bleeder Loaded Brake Caliper (ruffstuffspecialties.com) or Cadillac El Dorado Caliper Set with Parking Brake Lever (ruffstuffspecialties.com)

Requires steel wheel 15" with a maximum 4" back spacing

NAPA Part numbers for Front 4x4 Chevy Calipers and Bronco Rotors:

Caliper ONLY: LH - N4674, RH - N4673 - Both of these are LATER year part numbers

OR

LH - N4597, RH - N4596 - Both of these are EARLIER year part numbers

Ford 9" Rotor - NB 4885611 Premium Rotor. To use as a slip over rotor you may need to turn down your axle shaft flange

UP 85611 Ultra Premium

Write Review

★★★★★ ★★★★★

5/5 Stars out of 1 Reviews

1 ★

2 ★

3 ★

4 ★

5 ★

Verified Buyer

WHAT I WANTED

★ ★ ★ ★ ★ 5

landon gipe (MADTOWN, CA, US) | March 20th, 2016

THESE THINGS ARE THINK AND STRONG LIKE EVERY BODY SAYS ABOUT RUFFSTUFF PRODUCTS. THE ONLY DOWN SIDE IT I HAVE TO OPEN THEM UP A LITTLE TO FIT ON MY AXLE HOUSING BUT THAT IS TO BE EXPECTED WITH ANY TYPE OF FABRICATION. IF YOU WANT TO PUT DISC BRAKES ON A 9 INCH THEN THIS IS THE CHEAPEST WAY AND BEST WAY OF DOING IT.

WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.