Ford Rear Dana 60 Disc Brake Bracket Pair, 67-76

Ford Rear Dana 60 Disc Brake Bracket Pair, 67-76

Requires single steel wheel 15" with a maximum 4" back spacing

Here you are, an easy bolt on bracket for the 67-76 Ford F series full float D60 axles! E series typically requires modification to work. Our bracket uses the GM Caliper ('73-87 3/4 Ton 4x4 Front) because it is 1/2 the cost of the Ford and way less expensive to put together than the wedge system. The rotor is a 73-87 Chevy 3/4 4x4 Ton Front rotor. These were a long time coming but way worth the wait! 

All of our brake brackets are sold in pairs.

*NOTE* This is for Full Float axles only, does not work on Semi Float
*NOTE* Double check your wheel stud diameter and length. Studs should drop freely into the rotor. DO NOT press studs into the rotor. If your hub has too large of studs you will need to drill the rotors to accept them. Be sure to have minimum 5/8" lug nut thread engagement once the wheel is installed

Use these brackets with our calipers found here GM Dual Bleeder Loaded Brake Caliper (ruffstuffspecialties.com) or Cadillac El Dorado Caliper Set with Parking Brake Lever (ruffstuffspecialties.com)

NAPA Part numbers for '73-'87 3/4 Ton Front, 4x4, Chevy
Calipers and Rotors:
Caliper ONLY: LH - N4674, RH - N4673 - Both of these are LATER year part numbers
OR
LH - N4597, RH - N4596 - Both of these are EARLIER year part numbers
Rotor Only - 4885677 - all years
Brake line - H86572