Fully Welded Tie Rod For Jeep JK

Fully Welded Tie Rod For Jeep JK

Jeep JK Specific Off Set Tie Rod!! Fits 2007-2017 Jeep JK fully welded. Heavy Duty and a great addition for your vehicle! This kit Includes a fully welded Tie rod with hex head tube adapters, and Offset GM 1 ton TRE's (1LH & 1 RH). Tie rod is made of 1.5" x .25" thick DOM Steel tube pre fit for the JK Axles.

This kit will work on 17" steel wheels with a maximum 3.75 Backspacing. May not fit 17"inch factory wheels. It will NOT fit your factory steering stabilizer bracket! You may have to ream your knuckle's taper (depending on which knuckle you use) to accept the GM 1 ton TRE but the end result is more than worth the effort! Some aftermarket and factory wheels with deep backspacing could make contact with tie rod ends. It is the owners responsibility to be aware of changes to vehicle performance and handling characteristics.

• CHECK FITMENT OF WHEELS-TIRES PRIOR TO INSTALLATION. COMES PROFESSIONALLY WELDED!

You will receive:

• 1-1.5" X .25" wall DOM tubing
• 2- Offset Tie Rods with castle nuts
• 1 RH - 7/8" Hex Head Weld Bungs, 18TPI for Tie Rod Ends
• 1 LH - 7/8" Hex Head Weld Bungs, 18TPI for Tie Rod Ends
• 1 RH - 7/8" Jam Nuts, 18TPI for Tie Rod Ends
• 1 LH - 7/8" Jam Nuts, 18TPI for Tie Rod Ends

Additional Products you may need when installing this kit:

Ruffstuff Jeep JK Heavy Duty Drag Link Kit

Flat Mount Steering Stabilizer Bracket

90 Degree Steering Stabilizer Bracket

Reamer For Gm 1 Ton TRE's

Tapered Knuckle Inserts