Due to our Black Friday order volume we have about a 10 business day fullfilment time. We apologize for the inconvenience.
Secure Checkout
SKU: R2008 The Cure! for Jeep (CJ/YJ/TJ /XJ)
This cure is for the OEM Jeep Y link steering and is designed around the OEM Jeep tie rod end. Use on any other steering kit is at your discretion (Does not fit MOOG's factory replacement ends, they have a thicker housing). If you are using our upgraded GM 1 ton steering linkage for your Jeep please see part number R1768 Very similar to our product "The Cure" but specifically made to work with a factory Jeep steering set up in the Y-link or inverted T style steering position, using the stock tie rods. If running aftermarket GM 1 ton steering please see our other cure.
The Cure gives a self lubricated, fixed yet slightly flexible surface for the tie rod to rest against. The drag link does not flop forward or backward whatsoever yet in common usage it is allowed to roll which causes the steering wheel dead spot and allows for the tie rod roll. Also fits multiple 1/2 Ton solid axle trucks (Ford, Chevy and Dodge).
Not for use on tie rod ends at the knuckle or pitman arm. Fits most factory linkage of the below models, some shaving of cure may be required to get a snug fit without breaking the cure.Manufacturing tolerances in the pin and the taper cause some tie rod ends to seat higher or lower in the taper than others. One sign that the taper is not completely seated is if the cotter pin hole does not sit as far through the castle nut as it did with the standard dust boot. To verify your pin is seated in the taper, apply a marking compound (like gear marking compound, grease, lipstick, etc.) to the pin and tighten down the tie rod end then remove it again. Check the pin and taper to see if the marking compound is spread thinly and evenly around the pin. If it does not spread evenly, the pin is likely not seated completely. Sand down the face of The Cure for Jeep until the pin seats fully.
Depending on the shape of your tie rod ends, some filing may also be required to prevent interferences around the lip or face of The Cure.The Cure for Jeep is only meant to be used on the drag link tie rod end in Y-link steering. Using The Cure for Jeep at the steering knuckle and pitman arm tie rod ends will not allow necessary flex in your steering system and could lead to failure of your tie rod ends, The Cure, or other steering components.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
