1/2" Rod End Kit
This is our 1/2" Rod end set, comes as a single rod end, with a tube adapter for 3/4" ID tubing, as well as a jam nut and spacers of your choice.
With spacers, the mount width of this 1/2" rod end is 1.5" and is available for either a 1/2" or 3/8" bolt size. 1/2" Spacers offer limited misalignment, whereas the 3/8" spacer allow for 30 degrees of articulation.
This rod end set is rated to just over 16,000 lbs.
Tri Flow is the only product we recommend to service our rod ends, use of other products such as WD-40 or Blaster is never recommended and will void any warranty
*Tips to help prevent any seized or warped threads:
Correctly adjust welder settings and start your puddle on the tube. (Too much heat will warp the threads) Do not weld the tube adapter with the rod end threaded inside. (The two pieces cool at different rates and will lock them together) Wait until everything has completely cooled before threading your rod ends into the adapters
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
