DIY Custom Bumper Fabrication Package

DIY Custom Bumper Fabrication Package

This is a great starter kit we offer for building your rear swing out bumper. We see a lot of people building their bumpers the wrong way, when you use a swingout you must have a rest for the end or you will have an inevitable stress fracture. The swingout end must be supported when at rest, just a pad of steel that doesn't allow downward movement then situate the clamp to pull the arm even tighter against the rest to completey stop any upward movement. When following from behind you should not see any movement at all, if it moves it isn't resting on the pad or the clamp is not tight enough. You will save a few dollars by purchasing this kit instead of purchasing them separately.

Kit Includes:

• 2" x 6" Receiver Hitch Tube
• Spare Tire Spindle
• Swing Out Tire Carrier Latch
• Spare Tire Mounting Plate (See chart below to choose)