Dana 44 Y-Link & High Steer Kit (GM 1 Ton)

Dana 44 Y-Link & High Steer Kit (GM 1 Ton)

If you are unable to get your panhard/ track bar the length needed to match your drag link with a true cross over setup, then this is a great alternative. With the drag link mounting at the Y connection rather than at the arm, this will allow you to run a shorter panhard/ track bar. They are very simple to set up and ideal for many rigs that seem impossible to fit up a standard steering system. Together, all these reasons make them very difficult to pass up!

All of our steering kits are made of the best and strongest materials available. We use only 1.5" x .25" DOM Tubing with Hex Head bungs for adjustability. Our TRE's are all from the best forgings with metal on metal bearing surfaces and the correct Ackerman angle machined on our Hi Steer arms cannot be ignored. All of our Hi Steer arms also come with 2 holes so they can easily be used with Hydraulic or Hydraulic assist steering rams. All Hi Steer arms are also drilled for Reid Knuckles, if you have standard knuckles simply ignore the last hole.

Note

• Due to high demand please allow a 3-5 business day turnaround on Steering Kits
• This is a do it yourself style kit that requires welding by a competent person with the right equipment, don't skimp, do it right!
• You will need to check clearances with the steering wheel at lock to see if you need to add any bends before you cut it down to clear diff covers, sway bar mounts, etc.
• We supply more DOM than you need because it is way too easy to make a mistake in your calculations and you can always cut tube, growing it back is the hard part!

Kit Includes:

• 1 - 54" of 1.5" X .25" wall DOM tubing for the tie rod
• 1 - 43" of 1.5" X .25" wall DOM tubing for the drag link
• 2 RH - 7/8" Hex Head Weld Bungs, 18TPI for Tie Rod Ends
• 2 LH - 7/8" Hex Head Weld Bungs, 18TPI for Tie Rod Ends
• 2 RH - 7/8" Jam Nuts, 18TPI for Tie Rod Ends
• 2 LH - 7/8" Jam Nuts, 18TPI for Tie Rod Ends
• 4 - Tie Rod Ends, 1 for the Y Link, 2 Standard, & 1 High Angle TRE for the pitman arm
• 2 - Dana 44 High Steer Arms (L& R side)
• 8 - Dana 44 High Steer Arm 10.9 Stud and Cone Nuts

Additional Products you may need when installing this kit:

Reamer for GM 1 Ton TRE's

High Angle Tapered Knuckle Inserts
(Qty 1 for this kit)

Tapered Knuckle Inserts
(Qty 2 for this kit)

Flat Mount Steering Stabilizer Bracket

90 Degree Steering Stabilizer Bracket