Rear Bumper Tie-In Brackets For Jeep TJ/LJ

SKU: R2605-B Rear Bumper Tie-In Brackets For Jeep TJ/LJ

Click image to zoom

Description
Reviews

Rear Bumper Tie-In Brackets For Jeep TJ/LJ

Laser cut and bent from 3/16" steel. The Bumper Tie-In Brackets with added gusset to help reinforce the factory bumper mounting holes on the frame. A must have when running a heavier duty bumper with a tire carrier or recovery points to help prevent bending your rear crossmember. These come raw steel and will need to either be painted or powder coated. A single laser cut plate with two nuts welded on, easily slide in to the frame on each side to simplify installation.

Gusseted brackets for additional strength
Made to bolt on but can be welded for addition strength
Great addition to our LJ/TJ Rear Bumper
Comes with 1 pair of Brackets
Grade 8 Hardware included

Write Review

Currently Viewing Reviews with a rating of 5. Click here to reset.

★★★★★ ★★★★★

5/5 Stars out of 2 Reviews

1 ★

2 ★

3 ★

4 ★

5 ★

So simple

★ ★ ★ ★ ★ 5

Mark Cargile (Shasta Lake, Ca) | August 16th, 2024

These came with the rear bumper I ordered. I have to say, these are so much easier to install than the previous ones I had! The way the nuts are welded to a steel plate makes it so simple to get the nuts up into the frame of the Jeep! And as always, the welds are perfect. Nice job guys!

Verified Buyer

Quality

★ ★ ★ ★ ★ 5

Joel Hunt (Pismo Beach California) | April 12th, 2024

These brackets are perfectly welded and add much needed strength to the rear crossmember and bumper.

WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.