Secure Checkout
Due to our Black Friday order volume we have about a 10 business day fullfilment time. We apologize for the inconvenience.
Your Shopping Cart Is Empty

Secure Checkout

SKU: R2826 The Cure! For Jeep Moog Tie Rod Ends

The Cure! For Jeep Moog Tie Rod Ends
Click image to zoom
Purchase The Cure! For Jeep Moog Tie Rod Ends
  • The Cure! For Jeep Moog Tie Rod Ends

  • Not Yet Rated! - Leave a review
  • Part Number: R2826
  • Shipping Weight: 0.10 pounds

  • $25.00 $22.50 $25.0010% Off!

  • In Stock

The Cure! For Jeep Moog Tie Rod Ends

This Cure is for Moog's factory replacement Jeep tie rod end (ES3095R).

The Cure gives a self lubricated, fixed yet slightly flexible surface for the tie rod to rest against. The drag link does not flop forward or backward whatsoever yet in common usage it is allowed to roll which causes the steering wheel dead spot and allows for the tie rod roll. 

Not for use on tie rod ends at the knuckle or pitman arm. Fits most factory linkage of the below models, some shaving of cure may be required to get a snug fit without breaking the cure.
  • 1997 to 2006 TJ Wrangler, Rubicon and Unlimited
  • 1984 to 2001 XJ Cherokee
  • 1986 to 1992 MJ Comanche
  • 1987 to 1996 YJ Wrangler
  • 1993 to 1998 Jeep Grand Cherokee ZJ  

Manufacturing tolerances in the pin and the taper cause some tie rod ends to seat higher or lower in the taper than others. One sign that the taper is not completely seated is if the cotter pin hole does not sit as far through the castle nut as it did with the standard dust boot. To verify your pin is seated in the taper, apply a marking compound (like gear marking compound, grease, lipstick, etc.) to the pin and tighten down the tie rod end then remove it again. Check the pin and taper to see if the marking compound is spread thinly and evenly around the pin. If it does not spread evenly, the pin is likely not seated completely. Sand down the face of The Cure for Moog Tie Rod Ends until the pin seats fully.

Depending on the shape of your tie rod ends, some filing may also be required to prevent interferences around the lip or face of The Cure.

The Cure for Moog Tie Rod Ends is only meant to be used on the drag link tie rod end in Y-link steering. Using The Cure for Moog Tie Rod Ends at the steering knuckle and pitman arm tie rod ends will not allow necessary flex in your steering system and could lead to failure of your tie rod ends, The Cure, or other steering components.

Write Review
No Reviews Yet!
⚠ WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
Rate Product