DIY Rock Sliders - No Tubing
No bender? No Problem! Like many of our products, we wanted to offer a DIY Rock Slider Kit that can fit a wide range of vehicles. The most common design for a rock slider, the outside tube bends in at both sides and is welded to the inside tube. We would have to manufacture a dozen or more prebent lengths and still be limited by the sizes offered. This kit will allow you to build rock sliders at any length you choose. We use 3/16" steel plate to cap the ends of the tube at a 45 degrees angle and brace the inner and outer tubes 5.25" apart. There are three supporting gussets to brace the tubes in the middle and three 16" tubes and three "L" shaped frame plates to tie everything into the frame. This kit does not include the tubing (except for the legs that connect to the frame) but is designed for 1.75" x .120 wall DOM. Includes the pieces to do both sides of the vehicle. Looking for kits that come with the tubing click here.
- Kit Comes Unwelded.
- Includes enough pieces (except the tubing) for both sides of the vehicle.
Kit Includes
- 4 - 3/16" Slider End Cap Brackets
- 6 or 8 or 10 - 3/16" Slider Inner Gussets
- 6 or 8 or 10 - 1/4" Slider Frame Plates
- 6 or 8 or 10 - 1/4" Slider Frame Plate Gussets
- 6 or 8 or 10 - 16" Long 1.75" X .120" Wall Dom Slider Frame Tubes
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
